Skip to content

In Multi-copter Posted by

Dec 24

0 comments

AIOP v2.0 all in one pro Flight Controller

Currently one of the best value-for-money controller boards with high quality sensors, this version of board, AIOP V2.0 all in one pro Flight Controller, comes with reinforced USB connector which proved to be the weak point and works with MultiWii, MegaPirate, ArduPlane and ArduCopter.

Now well known controller AIOP V2.0 all in one pro Flight Controller is primarily used as multi rotor flight controller compatible with MultiWii and MegaPirate open source software autopilot but also works as fixed wing aircraft autopilot with ArduPlaneNG software. This piece of hardware includes everything you need for fully autonomous autopilot missions with decent, latest generation sensors such as MPU-6050 wich is combination of MEMS 3-axis gyro and a 3-axis accelerometer with an on-board Digital Motion Processor. The MS5611 is a high resolution altimeter sensor and according to Swiss designer particularly optimized for altimeters and variometers with an altitude resolution of 10cm. Board features built-in FTDI interface which makes programming and configuring easy as connecting micro USB cable. AIOP V2.0 all in one pro Flight Controller also has dedicated i2c port for GPS which works great with addon GPS module for this board based on LEA-6H.

AIOP V2.0 all in one pro Flight Controller is at the moment one of the best value for money flight controller that one can get without compromising on sensor quality.

Beware that AIOP V2.0 all in one pro Flight Controller version of the board does not have real 5V regulator built-in which means you can't feed it with 5-12V via external power connector which some older manuals state.

AIOP v2.0 all in one pro Flight Controller Features

  • Supported MegaPirateNG and MultiWii firmware
  • Up to 8-axis motor output
  • 8 input channels for standard receiver
  • 4 serial ports for debug/Bluetooth Module/OSD/GPS/telemetry
  • 2 servos output for PITCH and ROLL gimbal system
  • 1 servo output to trigger a camera button
  • 6 Analog output for extend device
  • A I2C port for extend sensor or device
  • Separate 3.3V and 5V LDO voltage regulator
  • ATMega 2560 Microcontroller
  • MPU6050 6 axis gyro/accel with Motion Processing Unit
  • HMC5883L 3-axis digital magnetometer
  • MS5611-01BA01 high precision altimeter
  • FT232RQ USB-UART chip and Micro USB receptacle
  • Onboard 16Mbit Dataflash chip for automatic datalogging
  • PCA9306DP1 logic level converter for I2C

Flight modes for Multiwii

  • One of the following basic mode
  • Acro
  • Auto Level
  • Altitude Hold
  • Heading Lock
  • Optional mode
  • HeadFree (CareFree)
  • GPS Hold (Need GPS receiver or Extend Board)
  • GPS Back to home position (Need GPS receiver or Extend board)

AIOP v2.0 all in one pro Flight Controller basics

  • Dimension: 50mmX50mmX11.6mm
  • Weight: 14.5g
  • Fixing hole spacing: 45mm
  • Hole diameter: 3.1mm

Related Posts

Comments

  • There are currently no comments